Everything else works and reports fine. . So you have to trigger your hub to go into inclusion mode as well and all should be well. They move just enough to let you slide the sensor board out. Or, do I have to go into the SmartThings and configure it in there? Best thing you can do is read up on home wiring and learn how to use a multimeter.
The smaller piece below it is just the magnet. Not that big of an issue - just wondering if anyone has any suggestions other than deleting and re-adding. Try a rescan of the device 3. The sensor comes in a nicely built box, with recyclable plastic on the inside. That will lead you to the following screen. Load up the app and click on Add A Thing at the bottom. In between it and the metal case, though, is a plastic divider.
Carefully, push them out a little bit. I can also configure it to alert me with lights in my house. Included is also a Setup guide and an Advanced Settings guide. The Zooz strip does not seem to have the feature. Just like any other Z-Wave device, go ahead and add it to your system.
I ended up changing the name to Sunroom Door once I had it installed. If you want to do that, continue reading. Anyhow just wanted to tell you that your device driver works very well. It doesn't always do this, but when it does, I'm concerned that it might be dragging my Z-Wave network down if these messages are really coming from the device. If I had speakers connected to my SmartThings hub, it can also do audible alerts. Response speed will depend on a number of variables, such as the signal strength and speed of your network, as well as distance between the plug and the hub.
I look forward to getting more deployed throughout my home. This is done by pushing a clip in on the Sensor piece. This will slide on its own when you plug a device into the outlet that is actively using it ie, charging a smart device. Has anyone experienced anything similar? Click on Security at the top and follow through the setup. A single press controls the left outlet, and a double press controls the right outlet on and off. There is a way to do it locally with a push button, but that doesn't help much with automation Thank you.
The Zooz strip does not seem to have the feature. You do that by clicking the little Gear icon in the top right corner of the Smart Home Monitor page. Since I'm new to homeseer from Vera I'm often not entirely sure what is happening. If not, skip on below to see how the interface looks like in SmartThings. Lastly, I noticed a new option for Scout Alarm. The design of the plug is all plastic, with each outlet on opposite sides of each other. When you first plug the unit into an outlet, it automatically goes into pairing mode.
Ability to turn off all lights on the power strip. I also really like that it reports battery life. I also like the design of the plug as I can now if I want have two plugs in the outlet fixture. Thank you for your hard work. In fact, everything except the sensor itself and the mounting hardware is recyclable. I'm not sure if this is a device issue or just the driver? There is a way to do it locally with a push button, but that doesn't help much with automation That feature is being deprecated on most Z-Wave plus devices.
Especially if your controller offers support for Amazon Alexa or Google Assistant which most do now. The Zooz S2 Double plug works great and I like the way the button work on the front, If I press it once the left plug turn on or off and if I press it twice in rapid succession the right plug turn on or off. So the fact that you have two outlets along with control for each both at once or individually , along with energy monitoring of both, is a good sell. Summary These were extremely simple to install. Both sides will begin to flash blue simultaneously. You will of course want to rename the other options to something more friendly.